Confirm the whole lighting assembly
An LED cornice creates a concealed lighting position, but the profile alone does not specify light output. Confirm LED strip width, channel clearance, driver, dimmer and control method with the lighting supplier. Check component instructions for ventilation, mounting and electrical requirements. Do not assume every tape light fits every channel.
Plan where the driver and connectors will remain accessible. Hiding them permanently behind finished trim can make maintenance difficult. Agree on the cable route and access point before fixing the profile. Electrical work should be completed by a qualified person under local requirements.
Test a representative length
Before installation, test a sample length of the profile and lighting assembly in the room. Check the intended colour temperature and dimming range against actual wall and ceiling colours. Inspect from normal seated and standing positions for visible LED points, dark patches, glare and brightness changes at corners.
A connector or sharp turn can interrupt the apparent light line. Dry-fit the profile and test the route before the adhesive cures. If the room has separate switched zones, label cable ends and confirm the control plan while wiring remains accessible.
Record the profile code and lighting component specifications together. If the LED strip is supplied separately, record its dimensions and approved driver. Photograph the accepted mock-up and settings so the site team has a reference.
Run the approved sample for long enough to check the lighting setup under normal room conditions, using the strip and driver instructions. Confirm that the driver capacity and control equipment match the selected strip; do not mix components based only on connector fit. Check whether the strip can be replaced without removing the moulding and keep any required service access clear. For a long room, test a full representative run rather than a small offcut, because connectors, voltage drop and corner transitions can change the appearance. Ask the lighting supplier or electrician to confirm the electrical design. Record the strip reference, driver reference, control method and accepted settings with the cornice profile code. These details make later maintenance less dependent on opening the finished ceiling.
Frequently Asked Questions
Q: Does LED cornice include the strip and driver?
A: Not necessarily. Confirm whether the quotation covers the moulding only or also includes strip lights, drivers, controls and connectors.
Q: Should LED cornice be tested before installation?
A: Yes. A mock-up can reveal fit, corner, glare and light-continuity issues before the profile is permanently fixed.